CONDUCTOR FILLED CONDUIT 1/4 TURN AND LOCK

Idea created by Douglass Garman on Oct 28, 2015
    Active
    Score-2
    • No one has voted for this idea

    THE IDEA I HAD (POSSIBLY NOT A GOOD ONE? ) WAS TO DESIGN A CONDUIT WITH CONDUCTOR ALREADY IN IT.  SAY FOR INSTANCE A 10' STICK OF EMT QITH 10 #12 THHN RATED CONDUCTORS ALREADY INSIDE THE CONDUIT,  THE ENDS WOULD HAVE A 1/4 TURN AND SLIDE LOCK ONE CONNECTOR END AND ONE PLUG END.  THEN WHEN TO A JB IT WOULD THEN ALSO TURN AND LOCK INTO THE JB BUT THIS JB WOULD BE A LITTLE LARGER OF COURSE BUT HAVE A TERMINAL STRIP TO THEN TERMINATE 10 # 12 CONDUCTORS TO AND GO TO ELECTRICAL APPARATUS/LOADS.  MAINLY APPLICABLE TO GETING SEVERAL RUNS OF CIRCUITS TO A DESTINATION AND THEN DISTRIBUTING THEM.  THE CONDUIT COULD BE BENT THE SAME AS BENDING AND RUNING CONDUIT BUT WHEN RAN AND FASTENED APPROPRIATELY THERE WOULD BE NO NEED FOR PULLING THE WIRE?  IT IS PART OF THE SYSTEM ALREADY?  NOT SURE HOW TO CHOOSE "In a Place" so I sent it to the only option I had available to me...which was EXPLORE?